Hygeia FIT Pro Manual Del Usuario página 9

5. SET-UP INSTRUCTIONS
5.1 Before First Use: Clean The Personal Accessory Set
Sanitizing is important for hygiene and serves to kill living organisms, such as bacteria or viruses.
WASH HANDS THOROUGHLY
Before first use, unless otherwise directed by your healthcare provider, prepare product for use as follows:
1. Disassemble all parts and place Breast Pump and AC Power Adapter and Cord off to the side.
2. SET ASIDE tubing adapter
apart from each other. The tubing adapter and tubing DO NOT need to be washed before first use
or typically after each use because milk does not come into direct contact with these parts. If
condensation does appear in the tubing, follow the directions below for cleaning the tubing.
3. Clean remaining pump kit parts as directed using breast pump cleaning instructions in Section
8 of this manual. See the Center for Disease Control website:
https://www.cdc.gov/healthywater/hygiene/healthychildcare/infantfeeding/breastpump.html
for additional cleaning guidelines.
NOTE: Inspect the tubing. If you find condensation in the air tube, wash and dry it
immediately or replace the tubing. If you see breast milk inside the tubing or tubing
connector do not attempt to wash, clean or sterilize the tubing or tubing connector. Instead
contact Hygeia Customer Service at 714.515.7571.
! IF YOU SANITIZE BY BOILING
DO NOT
WARNING: DO NOT
!
burning. Boiled water and steam from boiled water can cause severe skin burns, so use caution when
boiling parts in water and removing parts from boiling water.
 Please check pump kit parts for cracks, chips, tears or deformation before and after sanitization process.
CLEAN TUBING:
tube, wash and dry it immediately or replace the tubing. If milk is present in the tubing, do not attempt to wash or
clean the tubing. Instead contact Hygeia Customer Service at 714.515.7571.
HOW TO WASH TUBING:
1. Rinse tubing by pouring cool water and make sure the water flows through the entire tubing from one end to the
other.
2. Wash the tubing in warm, soapy water and rinse thoroughly.
HOW TO DRY TUBING:
Hang the tubing to air dry and make sure that the tubing is completely dry before using.
ART-70295-01-AA
with soap and water before touching breast pump, kit and breasts.
and tubing
allow boiling parts to contact bottom of pot. It may cause damage to parts.
leave boiling parts unattended. Remove parts carefully from boiling water to avoid
It is necessary to wash the tubing only if condensation is present. If condensation is present in the
- after your first use, you do not need to take these
ENGLISH | 9