Publicidad
Idiomas disponibles
Idiomas disponibles
Getting
started.
PLEASE KEEP
THESE IMPORTANT
SAFEGUARDS IN
MIND WHEN USING
THE APPLIANCE:
• Make sure the base is plugged in
for use.
• Never run the appliance while empty.
• Appliance accessories are not
intended to be used in the microwave
as it may damage the accessories.
•
Never
leave the appliance
unattended while in use.
Never blend hot or carbonated
liquids or ingredients when using
any sealed nutribullet cups.
Heated ingredients can pressurize
sealed containers when agitated
and violently expel hot contents upon
opening. Always start the blending
process with room temperature or
refrigerated ingredients and liquids
(21°C/70°F or cooler).
Pitcher assembly
& use.
Review all warning and caution
statements in the Important Safeguards
section (pg 2-9) and on the previous
page before proceeding to Step 1.
18
Use extra caution when
blending hot liquids or
ingredients in the pitcher.
Steam and splatters can escape
through the vented lid, potentially
causing scalding and/or burns.
NEVER
blend hot liquids in your
pitcher without the pitcher lid
and vented lid cap attached. The
vented lid cap is ventilated to allow
steam and pressure to release,
while guarding against excess
NEVER blend hot liquids
splashing.
in your nutribullet cups or any
other sealed vessel, only use the
vented pitcher.
When blending hot liquids in the
vented pitcher, add liquid and solid
ingredients to your pitcher below
their respective MAX lines. Attach
the pitcher lid with the vented lid
POWER
cap inserted. Press
, then
select desired program or begin
LOW
blending on
setting. Once
ingredients are integrated and
the mixture is level (no splashing),
increase speed as needed.
Always use care when opening
the pitcher lid after blending hot
ingredients making sure that excess
pressure has been released.
1
Place the motor base on
a clean, dry, level surface
such as a counter or table.
2
Place the pitcher on a
clean, dry, level surface.
Add the ingredients to the
pitcher, making sure they do
not exceed the MAX
line.
NOTE:
The blending pitcher is
marked with two MAX lines: one for
solid ingredients (higher line) and
one for liquids (lower line). When
filling the blender, make sure your
ingredients do not exceed their
respective MAX lines.
4
Place the pitcher (lid-side up)
onto the motor base and twist
clockwise to lock it into place.
When you hear the click, it's
locked and ready to blend.
NOTE:
You may need to twist the
pitcher slightly until you feel
it settle into the grooves on top of
the base.
3
Place the lid on top of the
pitcher and press down firmly
until locked in place. Place the
lid cap over the lid opening,
then press down and twist
until locked in place.
NOTE:
The motor will not run unless
the lid is locked in place.
5
Plug the power cord into
an electrical outlet and
press
POWER
to turn
on the blender. Once the
pitcher is fully locked and
the unit is plugged in, the
Blending Control Panel
will
illuminate and the unit will
be ready to operate.
NOTE:
If pitcher lid and pitcher are
not fully secured onto the base,
control panel will not illuminate.
19
Publicidad
