Publicidad
Idiomas disponibles
Idiomas disponibles
• Always turn off the scale before you install the protective top.
• Always secure the protective top and make sure the protective top extends and retracts before you return the product to
service.
T T o o o o l l s s R R e e q q u u i i r r e e d d : :
•
9/16" combination wrench
N N o o t t e e - - This procedure requires two people to complete.
1. Press the lock pin located on the top section of each post (A). Insert the post into the slot of the plastic structure (B)
(Figure 18). Repeat for the other posts.
N N o o t t e e - - Make sure that the post is secure by checking that the lock pin is in the slot on the outside of the plastic structure.
2. Install the four posts in the accessory bracket sockets (C) (Figure 18).
3. Using a 9/16" combination wrench, lock the posts in the accessory bracket sockets with the four hitch pins (D) (Figure
18).
P P o o s s i i t t i i o o n n i i n n g g t t h h e e p p r r o o t t e e c c t t i i v v e e t t o o p p w w i i t t h h s s u u p p p p o o r r t t s s
W W A A R R N N I I N N G G
• Always make sure to lock both lower rails before you leave a patient unattended.
• Always use the center of the lower rail to close the protective top.
EN
28
POSITIONING FRAME
F
LOWER RAIL
E
RELEASE KNOBS
C
ACESSORY BRACKETS
F F i i g g u u r r e e 1 1 8 8 – – P P r r o o t t e e c c t t i i v v e e t t o o p p w w i i t t h h s s u u p p p p o o r r t t s s
G
B
A
P
S
LASTIC
TRUCTURE
POST
D
PINS
1900-009-005 Rev AB.0
Publicidad
