Vermeiren Plego Manual De Instrucciones página 15

1
5. The LED indicator on the battery charger will show the status of the charging process:
 Red
- Charging
 Green - Standby / Fully Charged
6. Once the battery is fully charged, remove the battery charger from the wall socket and the
battery.
3.7.1 Battery charge indicator
There are two battery charge indicators:
On the battery pack:
1. Press button  on the battery pack.
2. The LED's of the battery charge indicator  will indicate the
battery charge level.
3.8 Switching the electric device On/Off
Press the on/off switch on the side of the battery.
3.9 Mounting / removing battery
The battery can be removed for easy charging away from the wheelchair.
To ensure full battery capacity, completely charge the battery with the
charger before using it for the first time. The battery can be recharged at
any time on the wheelchair or while removed from the wheelchair.
Instructions to charge the battery:
1. Switch the battery off.
2. If desired, remove the battery from the battery housing and prevent dirt
or fluids from entering the charging socket.
3. Connect the charger plug to the battery pack .
4. Connect the charger mains plug into the wall socket.
Operator console:
When the electric system is switched on, the battery indicator (2,
§3.3) will indicate the battery charge level.
 All LEDs on: battery fully charged.
 Only red LED on or blinking: immediately recharge battery.
Because of the wiring, both indications can deviate a little bit. In
that case, take the worst charge level indication.
13
EN
Plego
2023-09
Using your wheelchair
NL
2
1