Titan POWRLINER PL 3500 72V Instrucciones De Uso página 12

OPERATION
4.2
POWER UNIT (MOTOR) STARTUP /
SHUTDOWN
Follow these steps whenever instructed to start
i
up the motor.
Refer to the Honda instruction manuals (Battery
Pack, Battery Charger, and Power Unit) for all
safety information and usage instructions for the
Power Unit.
1. Make sure battery is charged and installed correctly.
2. Press the "POWER" button (Fig. 6, item 1) to switch the
power on. The green power indicator light (3) will turn on
after a few seconds.
3. Press "START" (2) to start the motor.
4. To shut off the motor, press the "STOP" switch. This will
also switch off power to the system.
INJECTION HAZARD. Shutting off the power to
the unit does not automatically relieve system
pressure. Follow the Pressure Relief Procedure
(Section 4.5).
12
4.3
Attention
3
1. Immerse the suction tube (Fig. 7, Item 1) and return hose
2. Turn the pressure control knob counterclockwise (3) to
3. Turn the relief valve (4) to PRIME (
POWER
1
2
START
STOP
4. Start the motor (refer to section 4.2).
5. Wait until the cleaning agent exudes from the return hose.
6. Turn the relief valve (4) to SPRAY (
7. Unlock the spray gun (refer to spray gun manual).
8. Aim the spray gun into an open waste container. Pull the
9. Spray the cleaning agent from the unit into an open,
PREPARING A NEW SPRAYER
If this unit is new, it is shipped with test fluid in
i
the fluid section to prevent corrosion during
shipment and storage.
thoroughly cleaned out of the system with
mineral spirits before you begin spraying.
Always keep the trigger lock on the spray gun in
the locked position while preparing the system.
Refer to the spray gun instruction manual for
trigger lock instructions.
Make sure that the spray gun does not have a tip
i
or tip guard installed.
(2) into a container with mineral spirits.
minimum pressure.
2
1
4
3
gun trigger on the right handlebar.
grounded (earthed) collecting container.
PL3500 72V
This fluid must be
circulation).
spray).