Titan POWRLINER PL 3500 72V Instrucciones De Uso página 8

DESCRIPTION OF UNIT
3
DESCRIPTION OF UNIT
3.1
AIRLESS PROCESS
A diaphragm pump takes in the coating material by suction and
conveys it to the tip. Pressed through the tip at a pressure of
up to a maximum of 3300 psi (228 bar, 22.8 MPa), the coating
material is atomized. This high pressure has the effect of micro
fine atomization of the coating material.
As no air is used in this process, it is described as an AIRLESS
process.
This method of spraying has the advantages of finest
atomization, cloudless operation and a smooth, bubble-free
surface. As well as these, the advantages of high production
speed and convenience must be mentioned.
3.2
INSTRUCTION MANUALS LIST
The following is a list of the available instruction manuals for
this unit.
Online items can be downloaded at www.titantool.com
DESCRIPTION
Operation Manuals
EN/F/ES
Service manual, Spare Parts
EN/F/ES
Operation / Service Manual, RX-80 Spray Gun
All languages
8
FORM # HOW TO FIND
2456923 • included with unit
• online
2456924 • online
538800 • included with unit
• online
3.3
ADJUSTING THE HANDLEBARS
Users can adjust the handlebar height for
i
operational comfort.
1. Remove the four bolts (Fig. 1, item 1), washers (2) and nuts
(3) that secure the handlebar weldment (4) to the frame.
2. Slide the handlebar weldment up or down to its new
position. Make sure the holes in the weldment line up with
the holes in the frame.
3. Secure the handlebar weldment to the frame using the
bolts, washers, and nuts removed in step 1.
3
4
3.4
HAND BRAKE
Be sure to engage the hand brake located behind
the right rear wheel whenever using the stencil
gun or whenever the sprayer is not in use in order
to keep it from inadvertently rolling down an
incline.
PL3500 72V
1
2