Publicidad
Idiomas disponibles
Idiomas disponibles
Using the short hose as an extension (applicable models only)
C
STEP 11 Power on
Plug the power cord into a wall socket protected by a fuse or circuit breaker. Then, tap
Laundry Hub.
For gas models
Make sure all gas connections, the exhaust line, and all wiring is connected correctly. Then, plug the power
cord into a power source and check the dryer's installation and operation using the final checklist in Step
12.
Untitled-2 43
1. Close the cold water tap. If you have a washer's cold
2. Using pliers, tighten the coupling an additional two-
3. Connect the Y-connector (A) to the brass male end
B
4. Using pliers, tighten the coupling an additional two-
5. Connect the angled end of the water hoses (C) to the
A
6. Using pliers, tighten the coupling an additional two-
7. If you detached the cold water hose from your
8. Open the cold water tap, and then check for any
water hose attached to the cold water tap, unscrew
and remove the hose. Then, connect the short hose
(B) to the cold water tap. Turn the coupling by hand
until it is tight.
thirds turn. Do not overtighten. You can damage the
coupling.
of the short hose. Turn the coupling by hand until it
is tight.
thirds turn. Do not overtighten. You can damage the
coupling.
filling valve at the bottom rear of the dryer. Turn the
coupling by hand until it is tight.
thirds turn. Do not overtighten. You can damage the
coupling.
washer, attach the hose to the free end of the
Y-connector, tighten the coupling by hand until it is
tight, and then, using a pliers, tighten an additional
two-thirds turn.
leaks.
to turn on the
English 43
2023-11-09
4:26:58
Publicidad
