Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Keep the Laundry Hub clean to prevent deteriorated performance and to preserve its life cycle.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing. Service personnel – Do not contact the following parts while the appliance is energized: Control
board, heat sink, motor, inlet valve and pump.
Self Clean+
Certain usage and environmental conditions may result in some residue build-up or odor in the washer
drum. To prevent this build-up or odor and keep your washer drum fresh and clean, perform the Self Clean+
cycle at least once a month or every 40 cycles. Perform the recommended procedure below when using the
Self Clean+ cycle.
1. Remove all items from the washer drum and ensure the drum is empty. Laundry left in the drum during
the Self Clean+ cycle may be damaged.
2. Turn on the Laundry Hub and select the washer.
-
The washer is selected as a default.
3. Turn the Navigation dial to select Self Clean+.
4. Touch and hold
.
CAUTION
If there is chlorine bleach left in the washer drum for an extended period of time, rust can occur.
NOTE
• The default water temperature for the Self Clean+ cycle is set to Warm. This temperature cannot be
changed.
• In the case where residue is present in the washer drum, add liquid chlorine bleach to the MAX level
line in the Manual detergent compartment before starting the Self Clean+ cycle. Do not add the liquid
chlorine bleach to the other compartments (This is only the case for Self Clean+ cycle).
• Do not exceed the max line. Do not use or mix any other detergent or chemicals during the Self Clean+
cycle. If necessary, run a Denim cycle after the Self Clean+ cycle has completed to help remove any
remaining residue.
Self Clean+ reminder
• After every 40 cycles, the washer displays the "Drum Clean needed" message for an hour to alert you to
run the Self Clean+ cycle.
• It is recommended to run the cycle regularly for hygienic purposes.
• You will see the Self Clean+ alert message when the washer completes a cycle. If you open the door, the
message disappears, and the display shows the Self Clean+ cycle setting screen automatically. At this
time, the dryer control panel displays the recommended drying cycle.
• The reminder will appear on the control panel for 5 additional consecutive cycles before turning off. The
next reminder will not appear until another 40 cycles have been completed.
Untitled-2 79
English 79
2023-11-09
4:27:03
Publicidad
