Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions
6
Operation
Installing the hot plate
The hot plate is permanently installed in a counter with a suitable
substructure for support; the display is installed separately in the same
counter or the optional gantry lamp modules. The counter must have a
lockable inspection opening that allows access to the base of the hot
plate and, if necessary, the power supply.
Once assembly is complete, the warning labels supplied with the
product must be affixed to the counter in a clearly visible position in
the immediate vicinity of the product.
Information on the layout of cut-outs and supports and the necessary
assembly work can be found in the separate assembly instructions.
Depending on the version with or without mounting frame, an addi-
tional sealing of the hot plate is required after assembly. Please
observe the information in the assembly instructions.
Electrical connection
The electrical connection of the hot plate is made via a hard-wired
connection at the installation site. The control unit and, if necessary,
gantry lamp modules are permanently connected to the hot plate.
For information on the layout of the connection and connection dia-
grams, please refer to the separate assembly instructions.
The connection must be carried out by a trained electrician.
WARNING
Danger of burns from hot surfaces when switched off
The surface of the hot plate can reach up to 140° C during operation.
Food containers and objects that are placed on the plate also heat
up. After switching off the hot plate, there is no way to tell if the plate
is still hot.
−
Make sure that the enclosed warning stickers are attached visibly
next to the product and are not covered.
−
Wear suitable protective gloves when removing objects from the
hot plate.
−
Do not place any heat-sensitive objects on the hot plate.
−
Only clean the surface when it has cooled down sufficiently.
Hot plate
13 / 23
Publicidad
