Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
16. DISPLAY function
-
Turn on/off the panel LED display.
-
Press the button
-
to turn off the panel LED display.
17. GEN function
1. Turn on the indoor unit at first, and press the
button for 3 seconds to activate it, and press it again to deactivate this function.
2. Under this function, briefly press the button
to select the general type L3- L2-L1- OF (OFF).
3. Select OF and wait 2 seconds to cancel.
18. SELF-CLEAN function
19.
-
Only optional for some heating pump inverters.
-
To activate this function, first turn off the indoor unit, then press the
-
button. Then, you will hear a beep, and
-
will appear on the remote control display.
1. This function helps to remove accumulated dirt, bacteria, etc. from the interior evaporator.
2. This function lasts about 30 minutes, and will return to the pre-setting mode. You can
press the
button to cancel this function during the process. You will hear 2 beeps when it is ending or
cancelled.
-
It is normal if there is some noise during operation, as plastic materials expand with heat
and contract with cold.
-
We suggest operating this function as the next environmental condition to avoid certain
safety protection features.
Internal unit
External unit
It is recommended to use this function every 3 months.
20. 8 °C heating function
1. Press the
button for 3 seconds to activate this function, and
display.
2. This function will automatically start heating mode when the room temperature is below
8°C (46°F), and will return to standby mode if the temperature reaches 9°C (48°F).
3. If the room temperature is above 18°C (64°F), the appliance will automatically cancel this
function.
114
AIRCLIMA 9000 SMARTFRESH/ AIRCLIMA 12000 SMARTFRESH/ AIRCLIMA 18000 SMARTFRES/
AIRCLIMA 24000 SMARTFRESH/ AIRCLIMA 12000 SMARTFRESH CONNECTED
will appear on the indoor LED display, and
Temperature < 30 ºC (85ºF)
5ºC (41ºF) < Temperature < 30ºC (86ºF)
will appear on the remote control
Publicidad
