Cameo EVOS W7 IP Manual De Usuario página 23

Select with UP and DOWN, confirm with ENTER, change value or status with UP and DOWN,
confirm with ENTER, return with MENU.
Setting the DMX start addresses Main and Pixel
Selecting the control signal for Pixel Control
Main Address with Master Dimmer (Yes) or
without Master Dimmer (No)
RGB or RGBW Pixel Control
Network settings: IP address: set 1st block,
confirm, set 2nd block, confirm... Subnet
mask: set 1st block, confirm, set 2nd block,
confirm...
Select universe and universe group
DMX control via XLR cable (XLR Only) or
W-DMX (Wireless Only). If "XLR First" is se-
lected, W-DMX serves as backup; if "Wireless
First" is selected, control via XLR cable serves
as backup.
Reset = Terminate the connection to all
W-DMX devices and put them on pairing
standby.
OPERATION VIA SACN AND DMX
The operating mode sACN+DMX offers the possibility of controlling the LEDs and the head mo-
vement separately via sACN and DMX. You can choose whether the LEDs should be controlled via
sACN and the head movement via DMX, or vice versa. Selecting this mode automatically activates
the 87-channel DMX mode. Starting from the main screen, press MENU to enter the main menu.
Use UP and DOWN to select the Control menu and press ENTER. Now select the menu item
sACN+DMX and confirm again. Information on the sub-menu items in sACN+DMX menu and the
corresponding setting options can be found in the table below.
23