Cameo EVOS W7 IP Manual De Usuario página 25

Select with UP and DOWN, confirm with ENTER, change value or status with UP and DOWN,
confirm with ENTER, return with MENU.
Setting the DMX start address Main
RGB or RGBW Pixel Control
DMX control via XLR cable (XLR Only) or
W-DMX (Wireless Only). If "XLR First" is se-
lected, W-DMX serves as backup; if "Wireless
First" is selected, control via XLR cable serves
as backup.
Reset = Terminate the connection to all
W-DMX devices and put them on pairing
standby.
SLAVE MODE (Slave)
Starting from the main screen, press MENU to enter the main menu. Use UP and DOWN to
select the Control menu and press ENTER. Now select the menu item Slave and confirm again.
Information on the sub-menu items in the Slave menu and the corresponding setting options can
be found in the table below. Connect the slave and the master units (same model, same soft-
ware version) with a DMX cable (Master DMX OUT – Slave DMX IN) or via W-DMX and enable the
stand-alone mode Scenes on the master unit. The slave unit will now follow the master unit.
Select with UP and DOWN, confirm with ENTER, change value or status with UP and DOWN,
confirm with ENTER, return with MENU.
DMX control via XLR cable (XLR Only) or
W-DMX (Wireless Only). If "XLR First" is se-
lected, W-DMX serves as backup; if "Wireless
First" is selected, control via XLR cable serves
as backup.
Reset = Terminate the connection to all
W-DMX devices and put them on pairing
standby.
25