Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE TIMER
1
1
1,2,3,4
2,4
3
6
u
The unit can be turned
on at a specified
time with the built-in
timer,
Preparation
Make sure the clock is set correctly,
(See page 5.)
Use the remote control.
1 Press the TIMER button repeatedly while pressing
the SHIFT button to display 0, and press the 11
button within 6 seconds.
O is
displayed,
and the hour flashes.
if you do not press the II
button
within
6 seconds,
another
operation
may start.
2 Designate
the hour of the timer-on
time by
pressing the -
or*
button, and the 11 button.
Repeat to designate the minute of the timer-on
time.
After you designate
the timer-on
time, one of the source name
flashes
alternately
on the display.
3 Press the FUNCTION button repeatedly to select
a source and press the II button.
You
can select a source by pressing
the <
or FP
button
as well.
o If the tuner is selected,
the band cannot be selected
in this
step.
4 Select the duration for the timer-activated
period
with the ++
or
> button and press the 11
button.
The duration
for the timer-activated
period can be set between
5 and 240 minutes
in 5-minute
steps.
5
6
Prepare the source.
To listen to a CD,
load the disc.
To listen to a tape,
insert the tape into the deck.
To listen to the radio,
select the desired band and tune into
a station.
To listen to the equipment connected to the AU}( jaclks,
set the timer of the connected
source (with an external timer)
and prepare for the play.
Press the POWER button to turn the unit otf afiter
adjusting the volume and tone.
@
remains on the display after the power is turned off (timer
standby
mode).
When the timer-on
time is reached,
the unit turns on and
begins play with the selected
source.
To check the specified time and source
Press the TIMER button while pressing
the SHIFT button on the
remote
control.
The timer-on
time, the selected
source
name
and the duration
for the timer-activated
period are displayed
for
4 seconds.
TIMER RECORDING
Timer
recording
is applicable
for TUNER
and AUX
(with an
external
timer) sources
only.
Press the TIMER button repeatedly while pressing the
SHIFT button on the remote control so that @ and
~
appear on the display, and press the II button.
Repeat the steps shown above from step 2 and insert 1he tape
to be recorded
into the deck after step 5.
To cancel timer stanby mode temporarily
Press the TIMER button while pressing the SHIFT button on the
remote control so that @ (and ~)
disappear
on the display.
To restore
the timer standby
mode, press again to display
0
(and m).
Using the unit while the timer is set
You can use the unit normally
after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume
and tone.
m
- Timer playback
and timer recording
will not
begin
unless
the
power is turned off.
Connected
equipment
cannot be turned on and off by the built-
in timer of this unit. Use an external
timer.
15
ENGLISH
Publicidad
