Getting Started
1. Open the battery cover: Using your thumb, apply firm pressure on the
ridges of the cover and slide it down and away from the Pocketalker
2.0.
2. Switch the Battery Type Switch to the position for the battery type
that will be used (Rechargeable/NiMH or Alkaline).
Battery Installation
Battery
Type*
Battery
Switch
Type*
NiMH
Switch
Alkaline
NiMH
Alkaline
AAA
Batteries
NiMH* or
Alkaline*
AAA
Batteries
NiMH* or
Alkaline*
PRESS HERE
WHILE SLIDING
Battery
Cover
PRESS HERE
WHILE SLIDING
SLIDE
*NOTE: If using rechargeable NiMH AAA batteries, the battery switch
Battery
MUST be switched to the NiMH position to allow charging!
Cover
3. Press 2 AAA batteries into place in the battery compartment,
being careful to observe correct placement of (+) and (–)
terminals.
4. Your Pocketalker system is supplied with the headphone
and earphone for best performance. Williams Sound offers
additional options - visit www.williamsav.com.
8
SLIDE
Internal Microphone
External Microphone
Jack
Clip
External Microphone
Internal Microphone
Jack
External Microphone
Jack
Clip
WARNING!
Clip
Recharge only batteries recommended by Williams Sound. To prevent
injury, do not attempt to charge Alkaline or other non-rechargeable
batteries!
Headphone/Earphone Jack
Left Side View:
Clip
Clip
Adjust
5. Wear the earphone or headphone so it fits comfortably.
Note: If using a single/mono headphone/earphone or a neckloop, turn the
Adjust
balance fully left (counter-clockwise) - this will maximize volume and help
to maximize battery life.
Balance Adjustment - Single/Dual Earphones
Battery
Compartment
Battery Compartment:
Balance
Adjust
Battery
Compartment
Left
Right
Lanyard Slot
(Mono)
Lanyard Slot
6. Adjust the balance for the type of headphone or earphone being
used. Using a small screwdriver, turn left (or right) to increase
(or decrease) the volume level on the left or right side of the
headphones.
Control
(Fully
counter-
clockwise
= Mono)
Headphone/
Earphone
Power On
Headphone/
Jack
Volume+
Power On
Earphone
Tone
Jack
Volume+
Adjust
Adjust
Dial
Tone
Adjust
Volume-
Dial
Power Off
Tone Adjust
Rotary Dial
Tone Adjust
Rotary Dial
Balance
Control
(Fully
counter-
clockwise
= Mono)
clockwise
= Mono)
Power
Green
Power
and
Volum
Rotary
Adjust
T-coil
Switch
Volume-
Power Off
Lanya
9