Celestron OMNI AZ 102 Manual De Instrucciones página 3

ASSEMBLING YOUR TELESCOPE
THE MOUNT
The Omni AZ mount and tripod come fully assembled, so setting it up is easy.
1 1
1. Remove the tripod and mount from the
bo x.
4 4
4. Place the accessory tray on top of the
center brace, lining up the threaded
post on the bottom of the tray with
the hole in the top of the center leg
brace. Rotate the tray clockwise until
it is secure.
2 2
2. Loosen the hand knobs at the bottom
of each leg and extend the inner
section to the desired length. Tighten
the knobs to secure the legs, being
careful not to overtighten.
5 5
5. Ensure the leg hinge bolts are secure
by snugging down hand knobs on
each leg.
OMNI A Z 102 TELESCOPE
3 3
3. Stand the tripod upright and pull the
tripod legs apart until the center brace
snaps into place.
ENGLISH | 3