Celestron OMNI AZ 102 Manual De Instrucciones página 4

OMNI A Z 102 TELESCOPE
INSTALLING THE SLOW MOTION CONTROL KNOBS
To attach the slow-motion control knobs to your mount:
1 1
1. Locate the supplied 2mm hex key
hidden inside the slot in the front of
the mount.
4 4
4. Place the rod over the D-shaped gear
shaft. Push inward to make sure it is
fully seated.
7 7
7. Locate the bottom gear shaft on the
mount. This is where you will place the
second slow-motion rod.
4 | ENGLISH
2 2
2. Use the hex key to back out the hex
screw on one of the slow-motion rods.
Do not back the screw out completely,
but just far enough that it does not
obstruct the inside of the rod.
5 5
5. Use the hex key to tighten the hex
screw onto the gear shaft.
8 8
8. Use the hex key to tighten the hex
screw onto the gear shaft.
3 3
3. Locate the upper gear shaft on the
mount. This is where you will place the
slow-motion rod.
6 6
6. Use the hex key to back out the hex
screw on the other slow-motion rod.
Do not back the screw out completely,
but just far enough that it does not
obstruct the inside of the rod.
9 9
9. Return the 2mm hex key to its storage
slot inside the front of the mount.