Publicidad
Idiomas disponibles
Idiomas disponibles
1. Turn gas off at control knobs and LP
cylinder tank valve.
2. Remove cooking grills and heat distribution
plates.
3. Remove screw from each burner "foot"
using a screwdriver.
4. Carefully lift each burner up and away from
valve openings.
5. Use a narrow bottle brush or a stiff wire
bent into a small hook to run through each
burner tube and flame port several times.
Note: Wear eye protection when performing
procedure 6.
6. Use compressed air to blow into burner
tube and out the flame ports. Check each
port to make sure air comes out each hole.
Valve Nozzle
Burner Opening
7. Wire brush entire outer surface of burner to
remove food residue and dirt.
8. Check burner for damage, if any large
cracks or holes are found replace burner.
IMPORTANT: Burner opening must slide
over valve nozzle.
9. Orient burners CORRECTLY by aligning
screw hole in burner to the left as shown.
Note: Make sure burner tubes align evenly
between cross over channels.
PROPER BURNER OPERATION
10
Debris
Crossover Channel
Burner Screw
Aligned Left
10. Replace screw on each burner and follow
the "Gas Leak Testing" section of this
manual. Relight burners to verify proper
operation.
11. Replace heat distribution plates and
cooking grills.
Proper Care & Maintenance
• To protect your grill from excessive rust, the
unit must be kept clean and covered at all
times when not in use.
• Wash cooking grills and heat distribution
plates with hot, soapy water, rinse well and
dry. Lightly coat cooking grill with vegetable
oil or vegetable oil spray.
• Clean inside and outside of grill by wiping
off with a damp cloth. Apply a light coat of
vegetable oil or vegetable oil spray to the
interior surface to prevent rusting.
• The stainless steel exterior surface of your
grill, can be cleaned with stainless steel
cleaner.
• Never apply paint to the interior surface.
Rust spots on the interior surface can be
buffed, cleaned, then lightly coated with
vegetable oil or vegetable oil spray to
minimize rusting.
Cleaning and Maintenance
Correct care and maintenance will keep your
appliance operating smoothly. Clean regularly
as determined by the amount of use. NOTE:
Clean the entire appliance each year and
tighten all hardware on a regular basis (1-2
times a year or more depending on usage).
Cleaning should be done where detergents
won't harm patio, lawn, or the like.
Suggested Cleaning Materials
• Mild dish washing liquid detergent
• Wire brush
• Nylon cleaning pad
• Hot water
• Paper clip
• Soft brass bristled brush
Publicidad
