•
Fill the tank with fresh, non-carbonated water (Fig.4).
•
Turn the appliance on by pressing the main switch I.
•
Buttons A-B-C blink simultaneously; the machine is heating up. When the buttons light up
steady, the appliance is ready to dispense coffee.
•
Fill the jug with the desired amount of milk.
•
Position the milk jug lid.
•
Make sure the milk jug knob is in the dispensing position (Fig.10).
•
Fit the milk dispenser fi rst and then the jug in its special place (Fig.5). Buttons D-E-F blink.
•
When buttons D-E-F light up steady, the machine is ready to dispense milk.
DESCALING SIGNAL:
•
When indicator light H is on steady YELLOW, it is advisable to do the descaling cycle
(See the section Descaling).
COFFEE CIRCUIT HEATING:
•
Buttons A-B-C blink simultaneously.
MILK CIRCUIT HEATING:
•
Buttons D-E-F blink simultaneously.
WHEN THE WATER FINISHES DURING OPERATION:
•
When indicator light G blinks RED and the machine beeps intermittently, the water tank
is empty.
•
Fill the water tank with fresh non-carbonated water (Fig.4).
•
Press one of the buttons A-B-C. Wait for the machine to complete the water circuit fi lling
cycle.
•
When buttons A-B-C light up steady, the machine is ready to use.
IF THE LEVER IS RAISED DURING DISPENSING:
•
Raising the lever when dispensing a product (Fig.1) can cause sprays of hot water.
Danger of scalding!
•
Indicator light G blinks RED and the machine beeps intermittently. Dispensing is
immediately stopped.
•
Close the lever (Fig.3).
•
Press one of the buttons A-B-C to reset the alarm.
•
The machine is ready to use again.
Cup / espresso cup height adjustment
•
The machine can be adjusted for using large cups or espresso cups.
•
Initially, the machine is arranged for large cups, to be placed on the drip-tray grille (Fig.8).
•
For better results when using espresso cups, lower the upper grille for cups (Fig.7).
•
An espresso cup can now be placed under the coffee dispenser (Fig.9).
English
Turn the appliance on
General operating indications
21