Caffitaly System S22 Manual De Instrucciones página 22

To dispense "Espresso" or "Caffè crema" (cream coffee), only use buttons A or B, lit up
WHITE. Depending on the amount, the same buttons are to be used for barley, ginseng or
cocoa capsule dispensing.
Button C, lit up BLUE, must only be used for "Filter coffee" or "Americano". The same button
can be used for tea, chamomile or herbal tea capsules.
Do not use button C for espresso or in any case for coffee with an intense fl avour. In this
function the machine is adjusted to low pressure and this reduces the "cream", diminishes the
fl avour of the coffee, and could cause an interruption of dispensing.
Buttons D-E-F are to be used only for dispensing drinks with milk,
always making sure the jug is correctly positioned in its special place (Fig.5), and that the knob
is in the dispensing position (Fig.10).
NB: Traces of the product just dispensed may remain in the machine circuit. To
ensure the full taste of the drink, it is advisable to do a rinse cycle when dispensing
a product other than coffee.
To do the rinse cycle, see the section "Rinse cycle".
After each dispensing of drinks with milk, it is advisable to do a cleaning cycle,
placing a container (at least 250ml) under the milk dispenser and turning the knob of
the milk jug to the right, anticlockwise (Fig.11).
Do not interrupt the cleaning cycle. At the end a beep sounds. Only then, turn
the milk jug knob to the dispensing position (Fig.10). It is advisable to carry out
this operation at least once a day if dispensing a beverage with milk.
• Raise the lever to open the capsule compartment (Fig.1).
• Insert the capsule, pressing it gently inside (Fig.2).
• Close the lever fully (Fig.3).
• Place a cup or espresso cup under the coffee dispenser (Fig.8 or 9).
• Briefl y press button A or B, depending on the desired coffee.
• The pressed button blinks. The machine stops dispensing when the programmed amount
is reached and a beep sounds.
• Raise the lever to eject the used capsule into the special drawer (Fig.1).
• Close the lever (Fig.3).
NB: The amounts of coffee dispensed can be programmed according to personal
taste and the size of the cups or espresso cups used. To program the amounts,
see the section "Programming the amount of coffee in a cup".
Programming the amount of coffee in a cup (button A,B,C)
• Raise the lever to open the capsule compartment (Fig.1).
• Insert the capsule, pressing it gently inside (Fig.2).
• Close the lever fully (Fig.3).
• Place a cup or espresso cup under the coffee dispenser (Fig.8 or 9).
• Press and hold the desired coffee button.
• On reaching the desired amount of coffee, release the button. The button is now
programmed. The amount of coffee dispensed can be programmed from a minimum
of 20 to a maximum of 250 ml.
• Raise the lever to eject the used capsule into the special drawer (Fig.1).
• Close the lever (Fig.3).
22
English
Correct use of the buttons
Dispensing coffee
Only use "original Caffi taly System capsules"