Publicidad
Idiomas disponibles
Idiomas disponibles
Dispensing cappuccino / latte macchiato (milk with a dash of coffee)
•
Fill the container with the desired amount of milk.
•
Make sure the milk jug knob is in the dispensing position (Fig.10).
•
Fit the milk dispenser fi rst and then the jug in its special place (Fig.5). Buttons D-E-F
blink. Wait until they light up steady.
•
Raise the lever to open the capsule compartment (Fig.1).
•
Insert the capsule, pressing it gently inside (Fig.2).
•
Close the lever fully (Fig.3).
•
Place a cup under the coffee and milk dispenser (Fig.8).
•
Briefl y press button D or E, depending on the desired beverage with milk.
•
The pressed button blinks. The machine dispenses the programmed amount of milk.
The coffee is then automatically dispensed.
•
Dispensing stops if the selected button is pressed during the cycle.
•
Raise the lever to eject the used capsule into the special drawer (Fig.1).
•
Close the lever (Fig.3).
NB: For better results, use milk at refrigerator temperature (approx. 4°-8°C). If the
milk container is removed and put in the fridge, it is advisable not to keep the milk
for more than 2 days. Do the "Milk jug cleaning cycle" (see the relevant section) after
every dispensing of a beverage with milk.
•
Fill the container with the desired amount of milk.
•
Make sure the milk jug knob is in the dispensing position (Fig.10).
•
Fit the milk dispenser fi rst and then the jug in its special place (Fig.5). Buttons D-E-F
blink. Wait until they light up steady.
•
Place a cup under the milk dispenser (Fig.8).
•
Press button F.
•
The pressed button blinks. Dispensing stops when the programmed amount is reached.
NB: For better results, use milk at refrigerator temperature (approx. 4°-8°C). If the
jug is removed and put in the fridge, it is advisable not to keep the milk for more
than 2 days. Do the "Milk jug cleaning cycle" (see the relevant section) after every
dispensing of a beverage with milk.
Programming the amount of milk / coffee in a cup (button D,E,F)
•
Fill the container with the desired amount of milk.
•
Make sure the milk jug knob is in the dispensing position (Fig.10).
•
Fit the milk dispenser fi rst and then the jug in its special place (Fig.5). Buttons D-E-F
blink. Wait until they light up steady.
•
Raise the lever to open the capsule compartment (Fig.1).
•
Insert the capsule, pressing it gently inside (Fig.2).
•
Close the lever fully (Fig.3).
•
Place a cup under the milk dispenser (Fig.8).
•
To program the button there are two ways:
A) Press and hold the button D, E or F for a few seconds, depending on the desired
beverage with milk. On reaching the desired amount of milk, press the same button
again. Dispensing of coffee starts. Press and hold the button for a few seconds. On
reaching the desired amount of coffee, press the same button again. The button is
now programmed.
B) Press and hold the button D, E or F, depending on the desired beverage with milk.
On reaching the desired amount of milk, release the button. Dispensing of coffee starts.
Press and hold the button. On reaching the desired amount of coffee, release the
button. The button is now programmed.
•
Raise the lever to eject the used capsule into the special drawer (Fig.1).
•
Close the lever (Fig.3).
English
Dispensing milk
23
Publicidad
