Publicidad
Idiomas disponibles
Idiomas disponibles
Only available in C module, installed in variant Ego 2 (T) slim C.
The pump has a built in web server which allows you to access your pump directly via an existing Ethernet
connection. The default address for access to the pump is 192.168.0.245/
The web server uses HTML pages to set and view:
•
Regulation mode settings
•
Regulation parameters (power, RPM, head, flow)
•
Relay settings
•
External control inputs settings
•
Current and previews error
•
Pump statistics (power consumption, run time and other)
Only available in C module, installed in variant Ego 2 (T) slim C.
Pump has built in Modbus client, through which we can access pump information using the RS 485 standard.
Modbus allows us to set and view:
•
Regulation mode settings,
•
Regulation parameters (power, RPM, head, flow),
•
Relay settings,
•
External control inputs settings,
•
Current and previews error,
•
Pump statistics (power consumption, run time and other).
For resetting the pump to factory settings all three buttons must be held for 5 seconds. This way the pump will
set itself to automatic mode, delete previous height and power settings and unlock setting pump operation (if
locked).
Resetting of communications module needs following steps:
1.
Disconnecting power from pump,
2.
Set the 10-step switch to number 9
3.
Turning the pump on and off again,
4.
Setting the 10-step switch to number 1,
5.
Turning the pump on.
Communications module should now be set to factory settings.
This also sets up the right twin pump.
8
8
(or 8 for left twin pump),
41
41
Publicidad
