TIDY LIVING TL-G30 Manual De Usuario página 8

Product Introduction
Remote control
Reserve
Start Auto cleaning
/Stop cleaning
Edge cleaning
Fixed-point cleaning
Suction control
Set Time
Make sure the time is set correctly to your local time before
setting a scheduled cleaning.
1. Make sure that the product has been turned on.
2. Press
display.
3. Press
Note: Make sure AM/PM is set correctly.
Time
4. Press
the time has been set.
* To ensure the time is set successfully, make sure RoboVac is turned on. You will
Manual direction
hear a beep when the time has been set.
control button
Cleaning reservation:
Recharge
1. Press "
2. Press the left and right buttons to set the hour and minute,
Room
and the up and down buttons to adjust the value.
3. Press "
Water control
4. Press and hold "
* In case of no reservation or reservation cancellation, the reservation icon and
time on the screen will disappear. If a reservation is made, the corresponding
icon and time will appear.
* The clock indicator will flash in the reservation mode. There will be one beep
sound after successful reservation and two beep sounds after successful
deletion of reservation.
* Install 2 AAA batteries before using the remote control for the first time. Make
sure the positive and negative ends are facing the correct polarity direction as
marked in the battery compartment.
05
on the remote control. The time will blink on the
to set the "hour" and "minute".
to save the setting. RoboVac will BEEP to indicate
" to enter the reservation setting mode.
" to confirm and save the settings.
" for 3s to delete the reservation task.