Publicidad
Idiomas disponibles
Idiomas disponibles
Insert the weight selector pin (44)
into the selector post (22), Fig.12, and
tighten nut (U) securely, Fig.13E.
Take the end of the foot pull-up
cable (48) and by following the arrows
marked on the cable, Fig.13, pass it
through the first pulley (A1), as shown
in Fig.13.
Next, pass the same tip through
lower pulley (B1; C1) Fig.13.
Continue passing the tip of the
cable (48) through the third pulley (D1)
Fig.13. Attach the end of the cable to
the carabiner (36) and to chain (34),
position it on the end joined to the
support on the base, Fig.13.
Note: After a while you may notice
that steel cable slackens a little due to
the cable settling into position.
To remedy this just tension the steel
cable by changing the chain link (34).
20.- Attach the top casing (28) fitting it
over the upper body (1) so that it slots
onto the main body (4) Fig.14.
Fasten on using screws (69).
REAR PROTECTION
ASSEMBLY.-
21.-Place the fixing points (98) in the
mesh (99) as shown in Fig.15.
Then, position the fixing points (98) on
the main body (4), place the screws
(70), with washers (84) and tighten, as
shown in Fig.16.
22.- Fit the chain (35) onto the leg
accessory hook (14) Fig.14, to be able
to do the leg exercises.
23.- Set the selector (40) as shown in
Fig.14 to be able to do the Butterfly
exercise.
POSITIONING THE WEIGHT
SEECTOR ROD.-
24.-Insert the weight selector (44) rod
into the orifice of the weights required
for the exercise, as shown in Fig.17.
25.-When the rod notch has been fed
through the weight selector tube (22),
turn the selector (44)rod anticlockwise,
so that the rod is held into place as
shown in Fig.18.
Check that the selector is firmly in
position and that it does not protrude
from the weight selector. To remove
the rod, turn it clockwise and pull.
For
optimum
conditions, the weights are already
marked with letters.
By checking the equivalence charts on
the bottom of the apparatus, you will
be able to check the exercised
strength as the meaning of each letter
is expressed in kilograms and pounds.
FOLDING THE SEAT.-
26.-To fold the seat, pull the safety rod
(39) and lift it in the direction of the
arrow as shown in Fig.19. The same
rod is used to put the seat back up.
Note: The seat can be put into two
different positions.
LEVELLING.-
27.-Once it has been firmly positioned
into place, check the base and ground
level of the machine. Levelling can be
improved by more or less swivelling
the adjustable feet (60) Fig.20.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
28
control
of
exercise
Publicidad
