Publicidad
Idiomas disponibles
Idiomas disponibles
Model and serial number
At the beginning of each test, the equipment model, as well its serial
number, are registered, making it possible to relate the obtained results
with their respective equipment Calibration Certificate.
3.1. Display messages
When turning the equipment on using the
On/Off switch, this introduction message
appears for a while.
The equipment is carrying out some
functional checkings.
Warns the operator that to be able to start
a test, the Test current control must be
at the zero position (fully counter-
clockwise). Otherwise, Start button will be
inhibited.
The equipment is ready to start a
measurement, thus the operator has to
press the Start button.
Indicates that the test current is not
enough to carry out the reading. It
appears at the beginning of each test and
it keeps on being there up to the operator
rotates the Test current control
clockwise.
When pressing the Save button this
message will be exhibited, indicating that
the measured value was saved in the
internal memory.
11
Publicidad
