AERMEC ECA 120 Manual De Instrucciones página 21

AUTOMATIC PROGRAM
1) PRESS THE MODE KEY (PROGRAMS)
Press the MODE key repeatedly until the
The speed is set to AUTOMATIC.
2) PRESS THE "ON/OFF" KEY
The conditioner starts running and the led lights up.
3) PRESS THE FAN KEY
Initially the fan is set to automatic.
Use the FAN key to select low
4) ADJUST THE TEMPERATURE
If the temperature is unsatisfactory, after at least one hour operation, it can be increased or
decreased:
– the temperature set can be increased by 1 to 5 degrees by means of the
– the temperature set can be lowered by 1 to 5 degrees by means of the
WHAT HAPPENS WHEN THE AUTOMATIC OPERATION MODE IS SELECTED
When the unit is started with all indicators displaied on AUTO, the microprocessor selects the
operation mode, the room temperature and the fan speed depending on the initial room tem-
perature (see table).
Room
temperature
below 21 °C
21 to 24 °C
24 to 26 °C
26 to 28 °C
over 28 °C
symbol appears.
Red = heating, Blue = cooling.
, medium or high
COOLING ONLY MODELS
selected
operation mode
DEHUMIDIFICATION
DEHUMIDIFICATION
COOLING
COOLING
COOLING
speed.
key;
key.
set
temperature
starting temperature
starting temperature DEHUMIDIFICATION
24 °C
25 °C
26 °C
3
HEAT PUMP MODELS
selected
operation mode temperature
HEATING
starting temperature
COOLING
COOLING
COOLING
2
5
1 4
set
23 °C
24 °C
25 °C
26 °C
Fig. 3
21