Publicidad
Idiomas disponibles
Idiomas disponibles
3
Maintenance of Conventional Parts
Disassembly and Installation of Panel and IDU Wiring
1
Disassembly of the Front Panel
There is no need to disassemble the panel frame when confirming the electrical cable distribution and condensed
water drainage.
① Pull out slightly on the panel from the buckle position on both sides of the unit body.
② Take the panel off the buckles along the gap between the panel and the unit body. Remove the panel obliquely
upward.
③ Hold the two lower ends of the front panel, gently pull the panel and then push the panel upward to remove it.
2
IDU wiring
Lead the power cable, ground wire, and signal cable from the back of the indoor unit to the front. For detailed
wiring steps, refer to section "Installation Instructions - Electrical Connection".
3
Installation of Front Panel
① Insert the upper buckles of the panel into the buckles on the panel frame.
② Place the panel and press the buckles.
[ Caution ]
Make sure that the front buckles of the panel fit the unit well, otherwise condensation and other risks may occur.
Panel assembly
66
Cleaning, Maintenance and After-Sales Service
Dismantle the panel assembly
Publicidad
