Husqvarna TS 300 E Manual Del Usuario página 12

4. Start the product to start the dust and cooling
To start the product on page 12 .
system. Refer to
To start the product
WARNING:
before you connect the product to a power
supply.
WARNING:
from rotating blade.
WARNING:
when the blade is installed and operates.
1. Push the ON button.
2. Make sure that the water pump starts automatically
when the motor starts.
3. Wait some seconds for the water slots in the
conveyor cart to be filled with water before you start
to cut.
To operate the product
WARNING:
blade during operation.
WARNING:
product, carefully read and understand the
safety chapter.
1. Make sure that the work area is safe. Refer to
area safety on page 5 .
2. Fill the frame with water and make sure that the
water pump is installed. Refer to
with water on page 11 .
3. Set the cutting depth. Refer to
depth on page 11 .
4. Start the product. Refer to
page 12 .
12
Push the OFF button
Keep your hands away
Do not move the product
Keep hands away from
Before you operate the
Work
To fill the frame
To set the cutting
To start the product on
5. Push the conveyor cart to the blade.
6. Stop the product. Refer to
page 12 .
To plunge cut
The cutting arm is spring loaded and can be adjusted up
and down.
1. Loosen the cutting depth lever (A).
A
2. Use the handle (B) to lift the blade.
3. Use the handle on the cutting arm to adjust the
cutting blade to plunge cut in the work piece.
To stop the product
1. Push the OFF button to stop the product.
2. Make sure that the cutting blade fully stops.
3. Disconnect the product from the power supply.
To set the blade to 45° angle
WARNING:
disconnect the power plug to stop the
product.
WARNING:
does not rotate.
The product can be set to 45° or 90° cutting operation.
Make sure to use gloves when you adjust the blade
angle.
To stop the product on
B
Push the OFF button and
Make sure that the blade
2282 - 002 - 07.02.2024