Husqvarna TS 300 E Manual Del Usuario página 14

Maintenance
Do maintenance on the wheels
of the conveyor cart.Refer to
do maintenance on the wheels of
the conveyor cart on page 14 .
Clean the wheels. Refer to
do maintenance on the wheels of
the conveyor cart on page 14 .
Do the maintenance on the wa-
To do main-
ter pump. Refer to
tenance on the water pump on
page 14 .
Clean the water pump. Refer to
To clean the water pump on
page 14 .
To clean the product externally
CAUTION:
washer to clean the product.
• Clean the product externally after each operation.
• Remove grease and oil from the handle.
To do maintenance on the wheels of the
conveyor cart
1. Stop the product.
2. Disconnect the power cord.
3. Do a check of the wheels on the conveyor cart.
4. Clean around the wheels of the conveyor cart.
5. Replace the wheels if they are damaged.
To do maintenance on the water pump
1. Let water run through the water system for a short
period in order to prevent hoses to get blocked by
slurry.
To clean the water pump
1. Stop the product. Refer to
page 12 .
WARNING:
off and power cord disconneted before you
do troubleshooting.
Problem
The product does not start.
14
To
To
Do not use a high-pressure
To stop the product on
Troubleshooting schedule
Make sure that the motor is
Solution
Make sure that the power supply is correctly plugged in.
Do a check of the power cord.
Daily
X
X
X
2. Disconnect the power cord.
3. Disconnect the water pump from the product.
4. Remove the suction filter (A) from the water pump.
5. Remove the partition wall (B) and clean the surfaces.
6. Loosen the pump impeller (C).
7. Pull out the pump impeller and shaft (D).
8. Clean the parts and the housing.
9. Remove iron particles from the magnetic rotor shaft.
10. Make sure that the pump impeller is clean and turns
freely.
After usage
X
C
D
B
A
2282 - 002 - 07.02.2024