Worx Nitro WG350E. Serie Manual Original página 10

rate for which it was designed.
b) Do not use the power tool if the switch does not
turn it on and off . Any power tool that cannot be
controlled with the switch is dangerous and must
be repaired.
c) Disconnect the plug from the power source and/
or remove the battery pack, if detachable, from
the power tool before making any adjustments,
changing accessories, or storing power tools.
Such preventive safety measures reduce the risk
of starting the power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions
to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation . If
damaged, have the power tool repaired before
use. Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions and
10
the work to be performed. Use of the power
tool for operations different from those intended
could result in a hazardous situation.
h) Keep handles and grasping surfaces dry, clean
and free from oil and grease. Slippery handles
and grasping surfaces do not allow for safe
handling and control of the tool in unexpected
situations.
5) Battery tool use and care
the manufacturer. A charger that is suitable for
when used with another battery pack.
designated battery packs. Use of any other
c) When battery pack is not in use, keep it away
from other metal objects, like paper clips, coins,
keys, nails, screws or other small metal objects,
that can make a connection from one terminal
to another. Shorting the battery terminals
from the battery; avoid contact. If contact
contacts eyes, additionally seek medical help.
irritation or burns.
20V 30cm Cordless BL ChainSaw
e) Do not use a battery pack or tool that is
batteries may exhibit unpredictable behaviour
or excessive temperature
temperature above 130 °C may cause explosion.
g) Follow all charging instructions and do not
charge the battery pack or tool outside the
Charging improperly or at temperatures outside
6. SERVICE
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
1) General chain saw safety warnings:
a) Keep all parts of the body away from the saw
chain when the chain saw is operating. Before
you start the chain saw, make sure the saw
chain is not contacting anything. A moment
of inattention while operating chain saws may
cause entanglement of your clothing or body
with the saw chain.
b) Always hold the chain saw with your right
hand on the rear handle and your left hand on
the front handle. Holding the chain saw with a
c) Hold the chain saw by insulated gripping
surfaces only, because the saw chain may
contact hidden wiring . Saw chains contacting a
"live"wire may make exposed metal parts of the
chain saw "live"and could give the operator an
electric shock.
d) Wear safety glasses protection. Further
legs and feet is recommended. Adequate
chain.
e) Do not operate a chain saw in a tree, on a
ladder, from a rooftop, or any unstable support.
Operation of a chain saw in this manner could
f) Always keep proper footing and operate the
If liquid
and level surface. Slippery or unstable surfaces
may cause a loss of balance or control of the
chain saw.
g) When cutting a limb that is under tension , be
EN