Worx Nitro WG350E. Serie Manual Original página 15

3. TECHNICAL DATA
Type WG350E WG350E.X (3 - designation of
machinery, represen ative of battery operated
chain saw)
WG350E WG350E.X **
Voltage
Bar length
Chain speed
Oil tank capac-
ity
Chain pitch
Number of
chain drive
links
Chain gauge
Replacement
chain
Replacement
bar
Machine
weight
(bare tool)
** X=1-999, A-Z, M1-M9 there are only used for dif-
ferent customers, there are no safe relevant changes
between these models
*** Voltage measured without workload. Initial bat-
tery voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
SUGGESTED BATTERIES
AND CHARGERS
Category
20V Battery WA3644
20V Charger WA3880
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice
NOISE INFORMATION
A weighted sound pressure
20V 30cm Cordless BL ChainSaw
20 V Max ***
30 cm
140 ml
0.95 cm
45
1.1 mm
WA0145
3.23 kg
Type Capacity
4.0 Ah
2.0 A
L = 92.7 dB(A)
pA
K =3.0 dB(A)
pA
A weighted sound power
K =1.27 dB(A)
wA
Wear ear protection
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission value
a
2
h
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways
in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
L =100.7 dB(A)
wA
Uncertainty K = 1.5
EN
15