Worx Nitro WG350E. Serie Manual Original página 20

the ungreased side of the sprocket is in line with the grease hole. Repeat the lubrication procedure.
7. TROUBLESHOOTING
The following table gives checks and actions that you can perform if your machine does not operate
WARNING: Switch off and remove the battery pack before investigating fault.
Symptom
Chainsaw fails to
operate
Chainsaw
operates
intermittently
Dry chain
20
Oil leakage during storage
down brake
over-heats
Chainsaw rips,
vibrates, does not
saw properly
20V 30cm Cordless BL ChainSaw
Possible Cause
Low battery charge.
Chain brake not in the proper
position.
Over heating
Applying too much pressure
while cutting.
Loose connection.
Internal wiring defective.
No oil in reservoir
Oil passage clogged
Residual oil
Brake does not stop chain
No oil in reservoir
Oil passage clogged
Chain is over tensioned
Dull chain
Chain tension too loose
Dull chain
Chain worn out
Chain teeth are facing in the
wrong direction
Remedy
Charge the battery pack.
Check to see if the chain brake
is in position . Refer to CHAIN
BRAKE for details.
Place the machine in a cool,
ventilated place to cool it down
Applying relatively less pressure
while cutting
Contact service agent.
Clean cap
Clean oil passage outlet
Drain the oil after use
Rest machine in a horizontal
position when not in use.
Rest machine on absorbing cloth
while in storage
Contact service agent
Clean cap
Clean oil passage outlet
Sharpen chain or replace
Sharpen chain or replace
Replace chain
Reassemble with chain in correct
direction
EN