Frigidaire GLGC30S8CSB Instrucciones De Instalación página 6

4. Provide an Adequate Gas Supply
This cooktop is designed to operate on natural gas at 4"
(10.2 cm)of manifold pressure only.
A pressure regulator is connected in series with the
manifold on tile cooktop and must remain in series with
tile supply line.
For proper operation, tile maximum inlet pressure to
the regulator must be no mere than 14" (35.6 cm) of
water column (W.C.) pressure.
For checking the regulator, the inlet pressure must be at
least 1 " (2.5 cm) (or 2.5 kPa) greater than the regulator
manifold pressure setting. The regulator is set for 4"
(10.2 cm) of manifold pressure, tile inlet pressure must
be at least 5" (12.7 cm).
The gas supply line to the cooktop should be Y2" (1.3
cm) or sA" (7.9 cm) pipe.
5. LPiPropane Gas Conversion
This appliance carl be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with
natural gas.
If you wish to convert your cooktop for use with LP/
Propane gas, use the supplied fixed orifices in tile
package containing tile installation Instructions Manual,
in a bag marked "FOR LP/PROPANEGAS CONVERSION".
Follow the installation instructions packaged with tile
orifices.
The conversion must be performed by a qualified service
technician in accordance with the manufacturer's
instructions and all local codes and requirements of the
authority having jurisdiction. Failure to follow
instructions could result in serious injury or property
damage. Tile qualified agency performing this work
assumes responsibility for the conversion.
Failure to make the appropriate
conversion can result in personal injury and property
damage.
Important:
Remove all packing material and
literature from cooktop before connecting gas and
electrical supply to cooktop.
5. Install Pressure Regulator
Install the pressure regulator with the arrow on the
regulator pointing up toward the unit in a position where
you can reach the access cap.
FIRE HAZARD. Do not make the
connection too tight. The regulator is die cast.
Overtightening may crack the regulator resulting in a gas
leak and possible fire or explosion.
Manual GAZFLOW Pressure
Shutoff Flare _@ Flare Regulator
Valve Union Union
On_ Flexible Connector [ _®'''"'"'_®J
Off
All connections must be wrench4ightened
Figure 8
Assemble the flexible connector from the gas supply pipe
to the pressure regulator in order: 1- manual shutoff
valve, 2- _/2" nipple, 3- _/2" flare union adapter, 4-
flexible connector, 5- _/2" flare union adapter, 6- _/2"
nipple, pressure regulator.
Use pipe-joint compound made for use with Natural and
LP/Propane gas to seal all gas connections. If flexible
connectors are used, be certain connectors are not
kinked.
The supply line should be equipped with an approved
shutoff valve. This valve should be located in the same
room as tile cooktop and should be in a location that
allows ease of opening and closing. Do not block access
to the shutoff valve. The valve is for turning on or
shutting off gas to the appliance.
To Appliance
Shutoff Valve
Figure 9
To gas supply line
Open the shutoff valve in tile gas supply line. Wait a
few minutes for gas to move through the gas line.