Publicidad
Idiomas disponibles
Idiomas disponibles
A.
Unpack burner bases and caps.
B.
Place burner base over each gas opening tube.
C. Make sure the burner is properly aligned and
leveled. Place burner cap over each burner
base.
NOTE: There are no burner adjustments necessary on
this cooktop.
2.
Turn on Electrical Power and Open Main Shutoff
Gas Vatve
Check the Igniters
Operation of electric igniters should be checked after
cooktop and supply line connectors have been
carefully checked for leaks and the cooktop has
been connected to electric power.
To operate
the surface burner:
A.
Push in and turn a surface burner knob to the
LITE position.
You will hear a little ticking noise;
this is the sound of tile electric ignitor which
lights the burner.
B.
After the burner lights, turn to the desired flame
size. The controls do not have to be set ata
particular mark.
Use the marks as a guide and
adjust the flame as needed.
4_
Adjust the "LO" or "SIMMER" Setting of Surface
Burner Valves (see Figure 12)
Push in and turn each control knob to the "LO" (or
"SIMMER") setting. The "LO" setting of each
burner has been set at the factory to the lowest
setting available to provide reliable reignition of the
burner.
If it does not stay lit on the"LO"
setting,
check the setting as follows.
Hollow Valve
System
A.
Allow cooktop to cool to room temperature.
B.
Light all burners by turning each control knob to
LITE until burners ignite, and then set them at
"HI".
C. _turn
the knob to tile LOWEST POSITION.
D. If burner goes out, readjust valve as follows;
Remove the surface burner control knob, insert a
thin-bladed screw driver into tile hollow valve
stem and engage the slotted screw inside.
Flame size can be increased or decreased with
the turn of the screw. Adjust flame until you
can quickly turn knob from HI to LOWEST
POSITION without
extinguishing the flame.
Flame should be as small as possible without
going out.
E.
If you need to adjust another burner, repeat the
steps from A to D above until all burners operate
properly.
When All Hookups
are Complete
Make sure all controls are left in tile OFF position.
Make sure the flow of combustion and ventilation air to
the cooktop is unobstructed.
Model
and Serial Number
Location
Tile serial plate is located on the underside of the
cooktop.
When ordering parts for or making inquires about your
range, always be sure to include the model and serial
numbers and a lot number or letter from tile serial plate
of your cooktop.
Your serial plate also tells you the rating of tile burners,
the type of fuel and the pressure the cooktop was
adjusted for when it left the factory.
Before
You Call for Service
Read tile Avoid Service Checklist and operating
instructions in your Use and Care Guide.
Check to make sure the house fuse or circuit breaker for
your cooktop are not blown or open.
Figure 12
Publicidad
