Publicidad
APPENDIX
RETAINING CLIPS FOR MULTICONTACT / WEIDMÜLLER QUICK FIT CONNECTORS
For countries that require compliance with the UTE-15-712-1 directive is necessary to use additional retaining
clips to assemble on the quick fit connectors in order to prevent accidental disconnection.
These retaining clips are not supplied in the accompanying assembly kit and they can be ordered directly
from Power-One, quoting the following codes:
Follow the procedure below for assembly the retaining clips on the quick fit connectors:
PROCEDURE FOR ASSEMBLING RETAINING CLIPS ON MULTICONTACT QUICK FIT CONNECTORS
•
Insert the retaining clip as shown in the figure.
•
Fit the male connector into the female
connector.
PROCEDURE FOR ASSEMBLING RETAINING CLIPS ON WEIDMÜLLER QUICK FIT CONNECTORS
•
Insert the retaining clip as shown in the figure.
•
Fit the male connector into the female
connector.
APPENDIX D
3G830020000 for Multicontact quick fit connectors
3G830010000 for Weidmüller quick fit connectors
4 - APP
Publicidad
