Introduction; Versions And References; Maintenance And Warnings - AKO 52042 Manual De Uso

1.- Introduction

Alarm module with remote control via GSM, with 4 digital inputs and two output relays.
The alarms detected in any of its inputs will be communicated sequentially by SMS to the 10 telephone numbers
saved in its internal phone book until one of them confirms their reception.
It also allows activating or deactivating at will any of the 2 output relays, using SMS messages.
The module is powered by the 230 V~ mains supply and incorporates a battery that guarantees its operation in the
event of a power failure.
It incorporates additional functions such as sending alerts in the event of a power failure or in the event of its
reestablishment, status query, etc.

2.- Versions and references

MODEL
AKO-52042
SOFTGSM
AKO-520421
3

.- Maintenance and warnings

Clean the surface of the equipment with a soft cloth, water and soap.
Ÿ
Do not use abrasive detergents, petrol, alcohol or solvents.
Ÿ
The wiring of the alarm input signals should NEVER be installed in a conduit together with power, control or
Ÿ
feeder cables.
Using the unit not observing the manufacturer's instructions may alter the appliance's safety requirements.
Ÿ
The unit should be installed in a place protected from vibrations, water and corrosive gases, where the
Ÿ
ambient temperature does not exceed the value indicated in the technical data.
The power circuit should be equipped with a switch for its disconnection of at least 2 A, 230 V, situated near
Ÿ
the appliance. The cables will be H05VV-F or H05V-K.
The section to be used will depend on current local regulations, but should never be less than 1 mm .
Ÿ
IMPORTANT
-The start-up time from when the power supply is connected until the unit is operating is
approximately 3 minutes.
-The SIM card must have the PIN code disabled before being installed in the alarm, refer to the
installation chapter.
-If you use a prepaid SIM card remember to regularly check that you have enough credit and its expiry
date, consult your GSM operator.
-When the unit is connected for the first time, the initial battery loading will start and this process will
last approximately 2 h, during which power failure alert messages can be generated.
Units that include rechargeable electrical accumulators:
This unit includes accumulators that should be replaced when the unit's battery life is under the duration
assigned in its specifications. At the end of the useful life of the unit, the accumulators should be taken
to a selective waste collection centre or returned to the manufacturer.
DESCRIPTION
GSM Alarm module
GSM Alarm configuration software
Optional external antenna
13
INCLUDED
Yes
Yes
No
2