AKO 52042 Manual De Uso página 16

Power failure alert message
If a power failure occurs, the alarm starts to operate in battery mode and sends an alert message to the
administrator.
In this mode, the relays remain deactivated. When the power supply is reestablished, the alarm will send an alert
message to the administrator and the relays will return to the status they were in before the fault.
The alert message for both cases is customisable (see page 20).
Status query
To consult the unit status at any time, send "STATUS, <administrator password>".
Example:
After a few seconds, the alarm responds with a message similar to this one:
Input1: NO ALARM Input2: ALARM
Input3: NO ALARM Input4: NO ALARM
Battery: OFF
ALARM: Active alarm in the indicated input.
Inputx
NO ALARM: Inactive alarm in the indicated input.
OFF: Unit operating with power supply at 230 V.
Battery
ON: No power supply at 230 V, unit battery-powered
Battery On
Battery Off
STATUS, 1234
Send
16