Installation - AKO 52042 Manual De Uso

6.- Installation

6.- Installation 6.- Installation
Figure 1
Figure 3
1
2
3
IMPORTANT: IMPORTANT: IMPORTANT:
-Before starting to install the alarm, check that there is enough coverage in the installation place. -Before starting to install the alarm, check that there is enough coverage in the installation place. -Before starting to install the alarm, check that there is enough coverage in the installation place.
-It should be installed so that the glands and the antenna are at the bottom, as shown in figure 1. -It should be installed so that the glands and the antenna are at the bottom, as shown in figure 1. -It should be installed so that the glands and the antenna are at the bottom, as shown in figure 1.
-Mark and drill the 4 fastening holes of the box on wall according to figure 2. -Mark and drill the 4 fastening holes of the box on wall according to figure 2. -Mark and drill the 4 fastening holes of the box on wall according to figure 2.
-Remove the cover (A) and fasten the alarm to the wall using 4 screws (B). -Remove the cover (A) and fasten the alarm to the wall using 4 screws (B). -Remove the cover (A) and fasten the alarm to the wall using 4 screws (B).
-Install the SIM card (fig. 3), remember that the PIN must be disabled. -Install the SIM card (fig. 3), remember that the PIN must be disabled. -Install the SIM card (fig. 3), remember that the PIN must be disabled.
-Assemble the supplied antenna (fig. 4). -Assemble the supplied antenna (fig. 4). -Assemble the supplied antenna (fig. 4).
-Make the connections according to the diagram on page 18, passing the cables through the glands. End -Make the connections according to the diagram on page 18, passing the cables through the glands. End -Make the connections according to the diagram on page 18, passing the cables through the glands. End
tightening the glands. If one of the glands is not used, it must have the supplied red cap installed (fig. 5). tightening the glands. If one of the glands is not used, it must have the supplied red cap installed (fig. 5). tightening the glands. If one of the glands is not used, it must have the supplied red cap installed (fig. 5).
-Connect the battery (fig. 6) and check that the operation and battery charging LEDs are on and that the coverage -Connect the battery (fig. 6) and check that the operation and battery charging LEDs are on and that the coverage -Connect the battery (fig. 6) and check that the operation and battery charging LEDs are on and that the coverage
LED flashes every 3 seconds. LED flashes every 3 seconds. LED flashes every 3 seconds.
-Close the cover (A). -Close the cover (A). -Close the cover (A).
B
Figure 4
A
Figure 2
Figure 5
17
113.2
180.8
Figure 6