RHINO RH-90711 Manual De Instrucciones página 10

Back-seam oper-
P45
ation duty cycle
(%)
Motor stops with
P46
a reverse angle
after trimming
Adjustment of
P47
reverse angles
after trimming
Low (Positioning)
P48
Speed (RPM)
Trimming Speed
P49
(rpm)
The time of Foot
P50
lifting
Lift foot full force
P51
time (%)
The time of Foot
P52
down
Cancel Foot
P53
Lifting when
Half-Heeling the
Pedal
Trimming Time
P54
(ms)
Setting Wiper
P55
Timing
Needles Goes
P56
Up Automatically
as Power turned
on
Protection time
P57
for foot lifter (s)
Up Position Ad-
P58
justment
1-50 25 Back-seam action to periodic power output
ON/ OFF ON: It will automatic as reverse function after
OFF trimming (angle adjustment according to the
50-200 160 Adjusting at reverse direction after trimming
100- 210 Setting Positioning Speed
500
100- 300 Adjusting trimming speed
500
10-990 250 Adjustment of foot lifting action
1-50 25 Adjustment for Duty-Cycle of Foot Lifter /
Back-Tacking (Fine tuning can reduce the
over-heating)
10-990 120 Delay starting motor, ensure that the foot is put
down.
ON/ OFF ON: Pedal half heeling without foot lifting func-
OFF tion.
OFF: Pedal half heeling with foot lifting function
10-990 200 Trimming sequence time setting
10-990 30 Wiper sequence setting
0-2 1 0: always not to fi nd a position
1: always looking for positioning
2: If the motor is positioned on the no longer fi nd
location (only with magnet motor)
1-60 10 It will automatically come down when foot lifter
keep lift over the setting time.
0-1439 1120 Up Position Adjustment
The needle will advance stop when the value
decreased.
The needle will delay stop when the value in-
creased.
9