RHINO RH-90711 Manual De Instrucciones página 5

Parameter
Decrement Key
Start/End Back-
Tacking Selection
Free Sewing
Shortcuts
Fixed Stitch
Shortcuts
Continuous Back
Seam Shortcuts
Multi-Section
Needle Shortcuts
Automatic
Trigger Button
Presser Foot Lift
Shortcuts
Thread Clamping
and Foot Lifting
Shortcuts
Shortcut
Functions
Slow Sewing
Start Shortcuts
Needle Position
Stop Switch Key
Needle Half-
Stitch Button
Descripción clave
Tecla de función
(Entrar en el área de
parámetros)
Botón Intro y Guardar
Decreases stitch number or parameters, or the setting
value in respective sections or parameter selection.
Select to start back seam in section B, or in sections A
and B. The process can be executed once or twice as
needed.
Pressing down on the treadle starts the sewing
machine; releasing it stops the machine. Heeling back
initiates the automatic trimming cycle.
Activate the needle function set in section E when its
icon is displayed.
Pressing down on the treadle completes all Bar-Tacking
seams D times, followed by automatic thread trimming.
When the display shows the icon, activate the multi-
section needle stitch function.
In Free Sewing mode, pressing this key emits a beep.
In Constant-Stitch Sewing mode, it performs the stitches
set in sections E, F, G, or H.
When the icon is displayed, the presser foot lifts
automatically after cutting or when the icon is on.
When the corresponding icon is on, the thread clamping
function is activated.
Set or cancel the tangent function. Off icon indicates the
function is disabled.
When the corresponding icon is lit, slow sewing start is
activated.
When the icon is lit, the needle stops in the down
position. If unlit, it stops in the up position.
Pressing this button performs a half stitch.
Símbolo Instrucciones
Para acceder al modo de parámetros de usuario
en condiciones normales, pulse la tecla [P]. Para
acceder al modo de parámetros como técnico,
mantenga pulsada la tecla [P].
Después de ajustar los valores de los parámetros,
pulse la tecla [S] para guardar y confi rmar los
cambios. Nota: Utilice la tecla [S] para guardar los
parámetros directamente.
4