RHINO RH-90711 Manual De Instrucciones página 9

Stitch Balance
P32
for Bar-Tacking 5
Stitch Balance
P33
for Bar-Tacking 6
Mode Selec-
P34
tion for Con-
stant-Stitch
Sewing
Slack line output
P36
function setting
(loose line power
set)
Wiper Function
P37
Selection or
Thread Clamp
Pressure Setting
Trimmer Func-
P38
tion Selection
Presser Foot UP
P39
/ Down at inter-
mediate stop
Presser Foot
P40
UP / Down after
Trimming
Display the
P41
sewing fi nished
quantity
Information
P42
Display
Setting Direction
P43
of Motor Rota-
tion
Parking efforts
P44
0-200 121 Start back-tacking A (C) paragraph stitch com-
pensation, 0-200 movement gradually lag; the
larger the value, A (C) the last paragraph of a
needle longer; B (D) of the fi rst paragraph, the
shorter pin
0-200 165 Starting back seam B (D) segment stitch com-
pensation, 0-200 movement gradually lag; the
larger the value, B (D) last paragraph a longer
needle, C section of the fi rst needle is shorter
A/M A A: One shot to pedal, it will automatic execute
Constant-Stitch M: Pedal-controlled; motor stops
as needed
0-11 5 0: no loose wire operation
1 to 11: Gradually increases the intensity of
loose wire
0-11 8 0: No Action
1: Wiper Action
2-11: Thread Clamp action and the pressure
gradually increased)
ON/ ON ON: Trimmer Valid
OFF OFF: Trimmer Invalid
UP/DN DN UP: Presser foot goes up automatically
DN: Presser foot keeps down (Controlled by
heeling pedal)
UP/DN DN UP: Presser foot goes up automatically
DN: Presser foot keeps down (Controlled by
heeling pedal)
0 Counting the fi nished-sewing quantity
NO1 Electrically controlled version serial num-
bers
NO2 Selected needle cassette version
NO3 Speed
NO4 Pedals AD,
NO5 Positioning angle
NO6 Under the positioning angle
NO7 Bus voltage AD
N12 Knee position sensor AD
CCW/ CCW CW: Clockwise CCW: counter clockwise
CW
1-45 16 Efforts to stop the machine when selecting
8