Olimpia splendid Bi2 WALL TR 1000 Instrucciones Para El Uso página 72

- Enable Autonomous configuration (paragraph "5.4", configuration parameter
"CF").
- Set the protocol type ASCII if SIOS CONTROL envisages B0863 or RTU if SIOS
CONTROL does not envisage B0863 (paragraph "5.4", configuration parameter
"bU").
- Set the address, each appliance must have an address different from all the
other units connected to the same BUS (paragraph "5.4", configuration parameter
"Ad").
- As regards mounting of the connections, proceed by following the indications
described in the previous paragraphs.
Once the operations have been completed, reposition the previously disassembled
parts, taking care to connect the display connector and the earth connection cable.
Secure the front shell through the 6 screws, then feed the machine.
• When the unit is configured for remote control, the remote con-
troller is disabled.
• It is not possible to control the flap from remote control.
• In this mode, the air probe installed on board the fan coil is ig-
nored.
5.4 - BOARD SOFTWARE CONFIGURATION
Work as follows:
a. Connect power supply, then ensure that the latter is set to any mode except for stand-by.
b. On the control panel, simultaneously press the key "
at least 5 seconds, until an acoustic signal is emitted.
c. The display shows the reference to the parameter
d. Scroll using the key "
e. Press the key "
-> Fa -> Po -> co -> CF -> ...
f. Press key "
g. Release and press key "
(Display blinking)
h. Press key "
i. Press key "
j. Press key "
Quit and give power voltage to the system to start the unit under
the new configuration.
EN - 24
" or " " (T1) until you select the desired parameter
" or " " (T1) to scroll the list of parameters: CF -> bU -> Ad
" (T2) to access the value
" (T2) for more than 3 seconds to change the value
" or " " (T1) to scroll the possible values of the parameters
" (T3) to confirm the value
" (T3) to exit the configuration or wait 20 seconds.
" (T2) and " " (T1) for