VERITAS SARAH Instrucciones Rapidas página 20

Raising the bobbin thread
1
Hold the upper thread with the left
hand. Turn the handwheel towards
you (counterclockwise) lowering it,
then raise the needle.
Replacing the needle
O
N
N
O
P
Changing the presser foot
1
1
3
EN
2
Gently pull on the upper thread to
bring the bobbin thread up through
the needle plate hole.
Please note:
If it is difficult to raise the bobbin thread, make sure the thread is not trap-
ped by the hinged cover or the sewing table.
Attention!
above operations!
Change the needle regularly, especially when it shows signs of wear or causes prob-
lems.
Insert the needle following the illustrated instructions.
Turn the handwheel towards you (counterclockwise) lowering, then raising the needle.
Turn the needle clamp screw counterclockwise to remove the needle. The flat side of
the shaft should be positioned towards the back.
Insert the needle as far up as it goes. Next, tighten the needle clamp.
Needles must be in perfect condition.
1. Problems can occur with:
2. Bent needles
3. Blunt needles
2
2
4
Turn the power switch to off („O") when carrying out any of the
ATTENTION!
when carrying out any of the below operations!
Removing the presser foot
Raise the presser foot using the presser foot lifter. Raise the
lever (e) and the foot disengages. (1)
Attaching the presser foot
Lower the presser foot shank (b) using the presser foot lifter,
until the cut-out (c) is directly above the pin (d). (2) The pres-
ser foot (f) will engange automatically.
Removing and Attaching the presser foot shank
Raise the presser bar (a) with the presser foot lifter. Removing
and Attaching the presser foot shank (b) as illustrated. (3)
Attaching the edge/quilting guide
Attach the edge/quilting guide (g) in the slot as illustrated.
Adjust as needed for hems, pleats, quilting, etc. (4)
20
3
Lay both threads to the back under
the presser foot.
Turn the power switch to off („O")
3