Publicidad
Idiomas disponibles
Idiomas disponibles
If the Husky Roller binds or is difficult to move; the housing assemblies may be tilted, this will
required adjusting the shims or 1/2" washers in the cross member. See Figure 11. It may also be
due to the base rails not being parallel. See Figure 1.
If the Husky Roller has too much or too little vertical lift in the housing assemblies; you can adjust
the anti-lift screws on the bottom of the housing assemblies. See Figure 13. To adjust; loosen the
lock nut and turn the set screw with a 3/16" Allen wrench. Adjustments should be made in small
increments. After adjustment; tighten the lock nut so that the set screw will not back out on its own.
The Husky Roller should easily roll back and forth. The set screws should be loose enough to not
drag on the roller tube, but tight enough to minimize the lifting of the roller housing.
Be sure both latch pins MUST fully engage in Holes 4 & 7. See Figures 13 & 14. If not, adjust
shims or 1/2" washers so that latch pins fully engage.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information /
Tech Support / Product Updates. 2020 Keystone Automotive Operations Inc. All Rights Reserved. 08/27/2020-Rev8
Trouble Shooting
Latch pins NOT
engaged fully
Page-10
Publicidad
