Descargar Imprimir esta página

Proxxon Micro-Cutter MIC Manual página 8

Ocultar thumbs Ver también para Micro-Cutter MIC:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
are the consequences. How to replace the saw
blade is described in these instructions under
"Care and maintenance".
Hold the device as shown in Fig. 2 and set it
down carefully on the work piece to be sepa-
rated. Please note that the maximum dipping
depth of the saw blade is 4 mm, so that only 4
mm-thick work pieces can be separated.
Adjust the feed speed to the requirements of
the work piece material and the cutting thick-
ness. To ensure long-lasting and reliable ope-
ration, handle the device with care and do not
overload it!
8 Care and maintenance
The device is primarily maintenance free. For
a long service life, you should clean your unit
after every use with a soft cloth or brush.
The external surface of the housing can be clea-
ned using a soft, possibly moist cloth. Mild soap
or other suitable cleansers may be used as well.
Do not use solvents or alcohol-based cleansers
(e.g. benzene, cleaning alcohols, etc) as these
could attack the plastic housing casings. In any
event, make absolutely certain that no liquids
penetrate the interior of the device.
8.1 Replacing the saw blade
Warning!
For the following steps it is imperative you dis-
connect the mains plug of the device!
Attention!
Worn or damaged saw blades must be repla-
ced. Risk of breakage and injuries! Decreasing
saw performance is a sure indicator of a dull
saw blade. Dull saw blades must be replaced
immediately as described further below. We
recommend the original Proxxon replacement
saw blades.
1. Carefully press the lock button
Please note:
- 10 -
- 10 -
Check screw 2 has a left-hand thread!
2. Using a suitable screwdriver, release and
unscrew the check screw 2. Attention: The
saw blade shaft might rotate along until the
lock button "fi nds" its correct position on
the shaft. This is noticeable when the lock
button engages completely at that point.
The shaft is then blocked.
3. Remove the saw blade 3. If necessary, fold
up the saw blade protection 4 a little more.
4. Insert the new saw blade. Please note: The
saw blade is non directional, so the assem-
bly position is arbitrary.
5. Replace screw 2 and tighten.
9 Accessories
For more detailed information on accessories,
please request our device catalogue from the
address specifi ed on the last page in the warranty
information.
Please note in general:
Proxxon bits and cutters have been designed
to work with our machines, which makes them
optimal for their use.
We will not assume any liability whatsoever
for the safe and proper function of our devices
when using third-party bits and cutters!
10 Disposal
Do not dispose of the device in the household
waste! The device contains valuable substan-
ces which could be recycled. If you have ques-
tions concerning this topic, please address your
municipal disposal company or other appropri-
ate municipal institutions.

Publicidad

loading

Este manual también es adecuado para:

28650