KikkaBoo i-MOOVE Instrucciones De Uso página 10

IMPORTANT! KEEP FOR FUTURE REFERENCE!
READ CAREFULLY!
I.PARTS
1.Headrest; 2.Small Headrest; 3.Internal cushion; 4.Buckle; 5.Crotch pad; 6.Central adjuster; 7.Adjuster strap; 8. Adult seat belts guide gap; 9. Shoulder belts;
10.Backrest Reclining Handle; 11. Rotation button; 12. ISOFIX button; 13.Headrest Handle; 14.Top Tether; 15.Child car seat; 16.ISOFIX Connector
II-IV. INSTALLATION
SEE FIG. 2.1
When the airbag is activated, it cannot be used in the passenger seat.
ADJUSTING HANDLE
( See Fig. 2.2 ) I. Buckle latches; II. Red button; III. Metal plate; ( See Fig. 2.3 ) I. ISOFIX anchor ; II. Guide socket
3 POINT VEHICLE BELT
( See Fig. 2.4 ) I. Vehicle seat buckle; II. Diagonal belt section; III. Lap belt section
PREPARATORY WORK AND FUNCTIONS
PREPARE ISOFIX SEE FIG. 3.1
If your car is not equipped with the ISOFIX guide socket, please insert the guide socket into the ISOFIX anchor.
TIP: ISOFIX anchors are located between the backrest and seat cushion. ( See Fig. 3.2 )
Press the ISOFIX button pushed rearward to the longest. ( See Fig. 3.3 )
PREPARE TOP TETHER SEE FIG. 3.4
1.Pull out the Top Tether and press the tether strap release button to extend the strap until it is long enough to connect it to the Top Tether anchorage point in the
vehicle.
2.If the Top Tether is tightened favorably and correctly the button will change to green.
ADJUST HARNESS AND HEADREST SEE FIG. 3.5
ADJUST HARNESS AND HEADREST IN THE 5 POINT HARNESS INSTALLATION FROM 40 UP TO 105 CM
1.Press down on the central adjuster and pull the shoulder belts towards you. ( DO NOT pull on the shoulder pads ) release the 5-point harness as far as it will go.
2.Pull uowards on the adjusting handle, whilst pulling up or pushing down the headrest to the required position. Adjusting the height of the headrest will allow for the
shoulder belts to be the same level as the child' s shoulders. ( See Fig. 3.6 )
HEADREST ADJUSTMENT FROM 100 TO 150 CM
1.Make sure the 5-point harness is removed.
2. Make sure the seat cushion is removed.
3. Press on the adjusting handle in the direction of the arrow to release the headrest and then adjust the headrest up or down to the desired position. Upon release of
this handle the headrest will be locked in place automatically.
4. The headrest is in the correct position when the diagonal belt section of the 3-point vehicle belt sits on the child' s shoulders and when you can t 2 ngers between
the Seat belt shoulder strap of the headrest and the shoulder of the child. ( See Fig. 4.1 )
USE 360O ROTATION SYSTEM SEE FIG. 4.2
ROTATION TO 180º IN REARWARD FACING FROM 40 UP TO 105CM REARWARD FACING
1.Pull the rotation button outwards to release the child car seat and then rotate the child car seat by 90º at where the child car seat will lock into lace automatically.
2.To rotate it back to the rearward facing position: pull the rotation button outwards to release the child car seat and then rotate the child car seat by 180º back to the
rearward facing position at where the child car seat will lock into place automatically.
3.Ensure the child car seat is in the rearward facing position and to the fullest recline position.
4.Double check the bottom supports.
ROTATION TO 180º FROM REARWARD FACING FROM 40 UP TO 105CM TO FORWARD FACING FROM 76 UP TO 150CM FORWARD FACING
1.Pull the rotation button outwards to release the child car seat and then rotate the child car seat by 180º at where the child car seat will lock into lace automatically.
2. Adjust the recline position to the desired position if necessary. Ensure the child car seat is at the forward facing position and the desired recline position.
FORWARD FACING FROM 76 UP TO 150 CM SEE FIG. 4.3
1.Pull the rotate button to push the child car seat and then push the child car seat to one to five forward facing gears. After releasing the rotate button, the child car seat
will be locked in place automatically.
2. Ensure the child car seat is at the forward facing position and the desired recline position.
WARNING: DO NOT USE FORWARD FACING BEFORE THE CHILD'S WEIGHT EXCEEDS 75 CM. IF THE VEHICLE IS EQUIPPED WITH AN ACTIVE FRONT SEAT
AIRBAG. DO NOT USE THE CHILD SEAT IN A REARWARD FACING POSITION.
REARWARD FACING INSTALLATION 40 105 CM, BIRTH TO APPROX. 15 MONTHS WITH 5 POINT HARNESS + ISOFIX + TOP TETHER SEE FIG. 4.4
4.7
1.Prepare the ISOFIX.
2.Ensure that the 5-point harness is correctly installed and ensure that the 5-point harness is correctly adjusted.
3. Adjust the child car seat to the fullest recline position and make sure that the recline mechanism is securely locked.
4. Rotate the child car seat to the rear of the vehicle against the direction of travel. Ensure that the child car seat is in the rearward facing position and the rotation
mechanism is securely locked.
5. Double check to make sure that the child car seat is set to the fullest reclined position.
6. Install the ISOFIX confirm that the indicator turns green. Unfold the bottom support.
7. Push the child seat towards the backrest applying a firm even pressure on both sides.
8. Children between 40 and 75 cm need cushions to sit in the seats . When it exceeds 75 cm take off the seat cushion.
SECURING THE CHILD WITH 5 POINT HARNESS SEE FIG. 4.8 4.10
1.Press the red button to release the 5-point harness buckle and press on the central adjuster to pull out the shoulder belts. DO NOT pull on the shoulder pads.
2.Place your child in the child car seat and ensure that your child' s back is lying flat against the backrest of the child car seat.
3. Guide the two buckle latches together and insert them into the 5-point harness buckle. An audible "click" will be heard once the buckle is locked.
4. Pull the adjuster strap towards you until the harness lies at and is close against your child' s body. ( See Fig. 4.9 )
SEE FIG. 3.7
ENGLISH
Only for seats with three-point seat belts.