Descargar Imprimir esta página

Husqvarna P 524XR EFI Manual De Usuario página 36

Publicidad

Idiomas disponibles

Idiomas disponibles

Make sure that the safety devices on the remote
control operate correctly and are not damaged.
Make sure that the that all controls go back into
neutral position when they are released.
Charge the remote control battery before you
operate the product in remote control mode. The
remote control will automatically be put to off if
the battery voltage is too low which can cause a
dangerous situation.
Charge or replace the battery when the information
center display shows low battery of the remote
Information center display on page
control. Refer to
42 and To charge the remote control battery with
the battery charger on page 70 .
Make sure that the bypass valves are closed. Refer
To disengage the hydrostatic transmission on
to
page 34 .
Push the throttle control to full throttle position on
the product before you operate the product with the
remote control. It is not possible to adjust the engine
speed with the remote control.
Make sure that the ignition key is in neutral position
and that the parking brake on the product is
To apply and release the parking
released. Refer to
brake on page 34 .
Make sure that the PTO button on the product is
disengaged. Refer to
on page 5 .
To use the remote control harness
WARNING:
always be correctly attached to the remote
control harness during operation in remote
control mode. Do not use a damaged remote
control harness.
1. Install the hooks on the remote control harness to
the harness loops on the remote control.
2. Put on the remote control harness.
36
PTO (Power Take-Off) button
The remote control must
3. Adjust the height of the suspension point with the
buckle of the remote control harness.
To learn how to operate the product in remote
control mode
Learn how to operate with the remote control on a large
level surface before you operate around obstacles or on
slopes. Continue until you feel sure that you can operate
the product with the remote control safely. Increase the
slope angle gradually as your knowledge increases.
WARNING:
how to operate the product safely can cause
dangerous situations for you or others.
WARNING:
parts. Keep body parts away.
WARNING:
can be thrown out during operation. Serious
injury or death may occur if you do not obey
the safety instructions.
Learn how to change between manual mode and
remote control mode on level surface. Refer to
before you operate the product on page 30 and To
start the remote control mode on page 37 .
WARNING:
apply the parking brake and stop the
engine before you enter the work area.
Learn how to stop the product with the machine stop
Machine stop button on the remote
button. Refer to
control on page 23 and To do a check of the of the
machine stop button on the remote control on page
24 .
Learn how to operate the product on a large level
surface with the cutting deck disengaged. Refer to
To operate the product with the remote control on
page 39 . Learn how the product moves when you
push the steering control. Keep a safe distance from
the product at all times.
Not sufficient knowledge of
The product has rotating
Look out for objects that
To do
Always stop the blades,
1929 - 003 - 05.12.2023

Publicidad

loading