Publicidad
Idiomas disponibles
Idiomas disponibles
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher rated SAE 30
weight. DO NOT use special additives.
1. Choose a viscosity according to table below.
5W-30, 10W-30
Synthetic 5W-30, 10W-30
°F
-20
0
20
°C
-30
-20
-10
STARTING TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
* The use of multi-viscosity oils (5W-30, 10W-30, etc.)
in temperatures above 40°F (4°C) will result in higher
than normal oil consumption. When using a multi-
viscosity oil, check oil more frequently.
** If using SAE 30 oil in temperatures below 40°F
(4°C), it will result in hard starting and possible
engine bore damage due to inadequate lubrication.
2. Place pressure washer on a level surface.
3. Clean area around oil fill.
4. Remove oil fill cap.
5. Pour oil slowly. Fill to the point of overflowing.
6. Replace oil fill cap, tighten securely.
NOTE: Check oil often during engine break–in.
30
32
40
60
80
0
10
20
30
Add Fuel
WARNING!
NEVER fill fuel tank when engine is running or
hot. Allow unit to cool for two minutes before
refueling. DO NOT light a cigarette or smoke
when filling the fuel tank.
WARNING!
full. Provide space for fuel expansion. Wipe
away any fuel spillage from engine and
equipment before starting.
•
Use fresh, clean unleaded automotive fuel and
store in approved, clean, covered containers. Use
clean fill funnels. NEVER use "stale" fuel left over
from last season or fuel stored for long periods.
100
40
•
Clean area around fuel fill cap, remove cap.
•
Slowly add fuel to fuel tank. Use a funnel to
prevent spillage. Fill tank to about 1.5" below top
of the filler neck.
•
Install fuel cap and wipe up any spilled fuel.
IMPORTANT: It is important to prevent gum deposits
from forming in essential fuel system parts, such as
the carburetor, fuel filter, fuel hose or tank during
storage. Also, experience indicates that
alcohol–blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leads to
separation and formation of acids during storage.
Acidic gas can damage the fuel system of an engine
while in storage.
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer. See
"Storage" on pages 16-17. NEVER use engine or
carburetor cleaner products in the fuel tank or
permanent damage may occur.
7
NEVER fill fuel tank indoors.
NEVER fill fuel tank completely
Tank
Fuel
Publicidad
