Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR PRESSURE
WASHER
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
To Start Your Pressure Washer
To start your engine-powered pressure washer for the
first time, follow these instructions step-by-step. This
starting information also applies whenever you start
the engine after you have let the pressure washer sit
idle for at least a day.
1. Place pressure washer near an outside water
source capable of supplying water at a flow rate
greater than 3.5 gallons per minute and no less
than 20 PSI at pressure washer end of garden
hose.
2. Check that high pressure hose is tightly connected
to spray gun and pump. See "Assembling Your
Pressure Washer" for illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment will result from failure to follow
this instruction.
5. Squeeze trigger on gun to purge pump system of
air and impurities.
6. Attach nozzle extension to spray gun. Tighten by
hand.
7. Position nozzle in low pressure mode (slide nozzle
forward) and squeeze trigger on spray gun to
relieve pressure caused by turning ON water.
Water will flow out of gun in a thin stream.
Continue to hold trigger until there is a steady
stream of water and no air remains in system.
Release trigger.
8. Engage safety latch to spray gun trigger.
OPERATION
9. Rotate fuel shut-off valve to "On" position (fully
10. Move throttle lever to "Fast" position, shown as a
11. Move choke lever to "Choke" position.
NOTE: For a warm engine, be sure the choke lever is
in the "Run" position.
12. Grasp handle and pull the recoil starter lightly until
13. Return recoil starter slowly. DO NOT let rope
14. When engine starts, slowly move choke lever to
15. If engine fires, but does not continue to run,
16. If engine fails to start after six pulls, move choke
How to Stop Your Pressure Washer
•
•
Safety Latch
NOTE: A small amount of water will squirt out when
you release the pressure.
9
counter-clockwise).
Fuel Valve shown in
"On" position
rabbit.
Throttle Lever in
"Fast" Position
you feel some resistance, then pull briskly.
"snap back" against starter.
"Run" position as engine warms. If engine falters,
move choke lever to "Choke" position, then to
"Run" position.
squeeze trigger on spray gun to relieve internal
pump pressure. Move choke lever to "Run"
position, and repeat steps 12 through 14.
lever to "Run" position, and repeat steps
12 through 14.
CAUTION
Avoid injury from kickback.
• Squeeze trigger on spray gun each time recoil starter is
pulled and engine fails to start.
Move throttle lever on engine to "Stop" position.
Squeeze trigger on the spray gun to relieve
pressure in the hose.
Publicidad
