Sub-Zero Designer Serie Guia De Instalacion página 11

Installation
Alignment
ANCHORING
Adjust the depth of the unit to fit flush with the surround-
ing cabinetry. Once aligned, verify the door/drawers open
properly, then install screws in each side trim.
SCREW
SIDE TRIM
CABINETRY
FACE
FRAME
PANEL
FRONT OF
THICKNESS UNIT
Anchoring
Water Line
Approximately 3' of 1/4" plastic tubing is connected
(.9 m)
to the unit with a preassembled 1/4" compression connec-
tion under the unit. The water line fitting connection kit,
provided with the unit, contains a 1/4" compression union
fitting for connection to the household water line.
Purge the water line prior to final connection to the unit.
This will remove any debris that may be present in the
tubing from installing the new water line. Connect the
plastic tubing from the unit to the house water supply line
with the fitting connection kit provided. Check all water
line fittings for leaks.
Locate the water line in the notch as shown in the illustra-
tion below.
IMPORTANT NOTE: If a reverse osmosis system is used, it
is recommended the water filtration system be bypassed
by removing the filter.
IMPORTANT NOTE: Water lines cannot be exposed to
freezing temperatures.
NOTCH
WATER LINE
CONNECTION
Water line
subzero.com | 11