EINHELL AGILLO 36/255 BL Manual De Instrucciones página 13

with the equipment. Children are not allowed
to carry out cleaning or maintenance.
•
Avoid abnormal working postures. Make sure
you stand squarely and keep your balance
at all times. Always maintain good footing
on inclines. Only operate the equipment at a
walking pace.
•
Risk of injury from dangerous moving parts!
•
The moving parts are not allowed to be
touched before the battery has been
removed and all moving parts have come to a
complete standstill.
•
Read the directions with due care. Familiarize
yourself with the operator controls and proper
operation of the equipment.
•
Never allow children or other persons who
are not familiar with the operating instructions
to use the equipment. Contact your local
governmental agency for information
regarding minimum age requirements for the
user.
•
Always keep in mind that the user of the
equipment is personally responsible for
accidents or hazards involving other persons
or their property.
•
Before use, always carry out a visual check to
make sure that the safety devices or covers
are not missing or damaged and that they are
correctly fitted.
•
Never use the equipment in bad weather
conditions and particularly never when there
is a risk of lightning.
•
Never use the equipment with a damaged
cover or safety device or when a cover or
safety device is missing.
•
Switch on the motor only when there are no
hands or feet within range of the cutting unit.
•
Always switch off the equipment and remove
the battery - when you leave the equipment
unsupervised.
- before you remove a blockage.
- before you examine, clean or work on the
equipment.
- after the equipment strikes a foreign body.
- when the equipment begins to make
unusual vibrations (examine immediately).
The equipment is not allowed to be put into
operation again until the cause of the unusual
vibrations is eliminated. If you fail to find the
cause of the vibrations, contact a service
center.
•
Risk of injury from the cutting unit! Keep
hands and feet away from the cutting unit!
•
Use only spare parts and accessories which
are recommended by the manufacturer.
Anl_Agillo_36_255_BL_SPK7_USA.indb 13 Anl_Agillo_36_255_BL_SPK7_USA.indb 13
EN
•
Examine and service the equipment regularly.
Important! The safety guard is there to
ensure your safety and the safety of others.
It is also essential for the equipment to
work correctly. Failure to comply with this
instruction will invalidate your warranty as
well as create a potential source of danger.
•
Never use your hands to try to stop the
cutting unit.
•
Always wait for it to stop by itself.
•
Use only genuine cutting units.
•
Make sure that the air vents are free of dirt.
•
Do not try to use the equipment to cut grass
which is not growing on the ground; for
example, do not try to cut grass growing on
walls or stones, etc. The person operating
the grass trimmer is liable for any damages
sustained by third parties within the
equipment's working radius as a result of its
use.
•
Do not cross roads or gravel paths with the
equipment switched on.
•
When you are not using the equipment, keep
it in a dry place out of the reach of children.
•
Use the equipment only in the way described
in these operating instructions and always
hold it perpendicular to the ground. Every
other position is dangerous.
•
Check at regular intervals that the screws are
properly tightened.
•
The area to be cut must always be kept
cleared of cables and other objects.
•
If the equipment has to be lifted for
transporting, be sure to switch off the motor
first and wait for the cutter to come to a
standstill. Each time you leave the equipment,
switch off the motor.
•
Under no circumstances are you to cut
against hard objects during use. This is
imperative to prevent injury to yourself and
damage to the equipment.
•
Use only original replacement parts when
repairing.
•
Before starting up the equipment, and after
any collision, check the equipment for signs
of wear or damage and have any necessary
repairs carried out.
•
Always keep your hands and feet away from
the cutting unit, especially when switching the
motor on.
•
Remove the rechargeable battery before
checking, cleaning or doing any work on the
machine and when it is not being used.
•
Acquaint yourself with the controls and how to
- 13 -
07.12.2023 14:06:05 07.12.2023 14:06:05